Quadro SW-Version 4.1.x Manuale Utente Scaricare il pdf (Pagina 17)

QCM Installation Guide Configuring Lines on the QCM

Configuring Lines on the QCM

If the Fast Configuration Wizard was previously used, a profile was created with one line (Line 1)

enabled.

To set up additional lines on the QCM (the profile), follow these steps:

1. Specify the desired number of lines on the General

page:

Quadro Communications Manager (SW Version 4.1.x)

OK.

Figure 14 Specifying the number of lines

1.1. Open the ToolsÆAdvanced

SettingsÆGeneral page.

1.2. From the Lines Number drop-down list (see

Figure 14), select the desired number of

lines and click

2. For each line configure an extension on the Quadro.

See Step 1.1

and Step 1.2 if the QCM is configured

as a local receptionist or Step 2.1

and Step 2.2 if

the QCM is configured as a remote receptionist.

3. Configure each line on ToolsÆAdvanced

SettingsÆLines page of the QCM.

3.1. Open ToolsÆAdvanced SettingsÆLines page (see Figure 15).

3.2. Select a line from the lines drop-down list.

3.3. Choose the Enable checkbox to be able to use the line after completing the

configuration. If the checkbox is not selected, the line will appear on the QCM’s GUI

grayed out (disabled) and no calls will be possible to make or accept on the line.

3.4. Specify the line registration settings: Username, Password, Quadro IP address and SIP

UDP port. For the description of these settings see Step 1.3

, PAGE 2 if the QCM is

configured as a local receptionist or Step 2.3

, PAGE 2 if the QCM is configured as a

remote receptionist.

3.5. Select the Auto Answer checkbox to configure the QCM to automatically go off-hook

when receiving a call

on the line. Note that

the AutoAnswer

timeout, the timeout

after which the QCM

will pick up an

incoming call, is set on

the General page. The

feature is useful if the

QCM is used in hands-

free mode.

Figure 15 Configuring Lines on the QCM

4. Click OK or Apply.

1 2 ... 12 13 14 15 16 17 18 19 20

Commenti su questo manuale

Nessun commento

Quadro SW-Version 4.1.x Manuale Utente Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi per centralini PBX Quadro SW-Version 4.1.x