Quadro Quadro4x Guida di Installazione Scaricare il pdf (Pagina 7)

QuadroE1/T1 Manual-I: Installation Guide Hardware Overview

Hardware Overview

QuadroE1/T1’s Rear Panel

1 Power supply socket. Use only the power adapter delivered with the QuadroE1/T1.

2 PHONE socket with a RJ-11 connector enables connectivity of a regular analog tele-

phone. This is a FXS (Foreign Exchange Station) analog port.

3 RJ-45 socket to attach the Local Area Network (LAN) via an Ethernet CAT 5 cable. If a

PC is connected directly to this socket, a straight cable is used. If an Ethernet hub,

router or switch is used, a crossover cable may be required.

4 RJ-45 socket to attach the Internet Uplink (WAN) via an Ethernet CAT 5 cable.

5 RJ-45 socket to attach the E1/T1 trunk . See Appendix: Pin Assignment of E1/T1.

6 The Reset button may be used in two ways: (1) to initiate a normal reset, (2) to carry

out a factory reset. A normal reset is executed by pressing the Reset button with a pa-

per clip for an instant.

Pressing the reset button and holding it down for 7 seconds or more will execute a fac-

tory reset. This will restore the factory defaults and clear all settings including the IP

address and the administration password you entered.

Please Note: A Factory Reset forces the default LAN IP address of 172.30.0.1 and

default admin password of 19

QuadroE1/T1; (SW Version 2.4.x) 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 40 41

Nessun commento

Quadro Quadro4x Guida di Installazione Pagina 7