Quadro Quadro4x Guida di Installazione Scaricare il pdf (Pagina 32)

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro

Step 2.4: Firewall Configuration

By default, Firewall configuration on the Quadro has medium security, which denies any in-

coming traffic from the WAN except for voice traffic.

Disabling the firewall is only required to access the Quadro’s management when the

Quadro is connected behind a router. To disable the firewall, open Firewall Configuration

from the Internet Uplink menu. Disable the firewall by deselecting the corresponding

checkbox and save changes.

Fig. I-29: Firewall Configuration page

Step 2-A: Using IP Lines

Before starting the IP Lines configuration, the appropriate IP phone should be connected to

the Quadro either to the WAN or LAN port. If the phones are placed on the Quadro WAN,

which is assumed by the default configuration, please ensure that the Connect IP phones

from WAN side checkbox is enabled on the Line Settings page (see Fig.I-30).

The Quadro2x, 2xi; 4x, 4xi; 16x, 16xi provides two options for configuring IP phones:

• The Plug-and-Play option is available for supported SIP phones only. The list of

these phones is given below

. The Plug-and-Play option does not require any

specific configuration except that the Enable PnP for IP lines checkbox should

be enabled on the Line Settings page (see Fig. I-31).

• The Auto-Configuration option is available for tested and supported SIP

phones. The list of tested SIP phones is given below

. The Auto-Configuration

option (described in detail below) requires specifying some basic parameters on

the Quadro and restarting the phone.

Each IP line should be configured individually from the Telephony menu, Line Settings

page, IP Line Settings tab.

Quadro2x, 2xi, Quadro4x, 4xi, Quadro16x, 16xi; (SW Version 5.2.x) 32

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Nessun commento

Quadro Quadro4x Guida di Installazione Pagina 32